This is what I'm making the front floorboards out of...an old set off an FLH for the rear passenger. I cut one up and this shows what I'm starting with. Basically, it's just the floorboard plate itself, minus all of the bracketry. I will make all the mounts for the frame and pivots, etc..

Not much to see here but a double function with the rear mount on this side. The rear mount will also be the end nut for the pedal shaft/pivot. The pieces I'm using are tapered. Both sides will be from the same style tapered stock then I'll put a pivot clevis on bottom of each foot board in 2 places. There's no way one mount is enough tokeep a foot board from breaking off...
This is for RIDING.

Here are the parts, ready to be connected to the frame

Here, the mounts are attached and awaiting the floor board.

Here's the finished right side

Here's the finished left side

Here's the underside, showing the pivots.

Here's a close-up of the underside.